Dear friends
I'm having trouble with a voluson 730 pro BT06 / 08. it does not load the softwere. I found a raw partition on hd. I need to recover the hd or reinstall the softwere. I have the installation cd and the backup cd. Could anyone please reinstall the softwere in this voluson?
thank you very much.
The best way to install software is by using a System Disk, and it sounds like you may have it. The software version to be installed depends on the hardware in the Voluson 730.
Disconnect all USB peripheral devices from the system. Insert the disk in the DVD drive and turn on the system. It should boot up to the V730 hard disk configuration utility menu. Select Change, and from there the process is automated. You will need to press the A key to activate the application software, and set the video type to PAL or NTSC. If you get a warning about the BT option, skip it by pressing Continue. (The Options are recovered by doing a Restore of the Full Backup.) Fill in the System Status Messenger, and after the system reboots again, restore the Full Backup.
Good luck,
Jim Carr
Advanced Ultrasound Electronics
Hi
It is not so hard.
1.insert the CD.
2.check the bot CD ram.
3.automatic boot cd came up.
4.chose media cd
5.here you can choose install new software or re install software.
You can read the service manual for more information .
Before any doing tack the option code .
Bay
Hi.
1.please check the mainboard.
Sometimes the mainboard is damage.
2.if the mainboard is ok check the bois and choose the boot cd ram.
And install the cd
(11)
marco antonio goncalez
voluson 730 pro not boot
July 03, 2019 10:26
Dear friends
I'm having trouble with a voluson 730 pro BT06 / 08. it does not load the softwere. I found a raw partition on hd. I need to recover the hd or reinstall the softwere. I have the installation cd and the backup cd. Could anyone please reinstall the softwere in this voluson?
thank you very much.
to rate and post a comment
(57)
(6)
Jim Carr
re: voluson 730 pro not boot
July 04, 2019 10:02
The best way to install software is by using a System Disk, and it sounds like you may have it. The software version to be installed depends on the hardware in the Voluson 730.
Disconnect all USB peripheral devices from the system. Insert the disk in the DVD drive and turn on the system. It should boot up to the V730 hard disk configuration utility menu. Select Change, and from there the process is automated. You will need to press the A key to activate the application software, and set the video type to PAL or NTSC. If you get a warning about the BT option, skip it by pressing Continue. (The Options are recovered by doing a Restore of the Full Backup.) Fill in the System Status Messenger, and after the system reboots again, restore the Full Backup.
Good luck,
Jim Carr
Advanced Ultrasound Electronics
to rate and post a comment
Masood Yousefi
re: voluson 730 pro not boot
July 25, 2019 10:27
Hi
It is not so hard.
1.insert the CD.
2.check the bot CD ram.
3.automatic boot cd came up.
4.chose media cd
5.here you can choose install new software or re install software.
You can read the service manual for more information .
Before any doing tack the option code .
Bay
to rate and post a comment
Uam
re: voluson 730 pro not boot
March 30, 2020 10:36
Hi.
1.please check the mainboard.
Sometimes the mainboard is damage.
2.if the mainboard is ok check the bois and choose the boot cd ram.
And install the cd
to rate and post a comment